Listening To The Radio; Adjust [Settings] Mode Settings - Kenwood KDC-208U Instruction Manual

SWITCH PRE REAR*
1
SUB-W: Selects whether rear speakers or asubwoofer are connected to the line out terminals on the
rear of the unit (through an external amplifier).
SP SELECT
I
OFF*
1 5/41
6 x 9/6/ OEM: Selects the speaker size for optimum performance.
F/W UP xX.xx IYES: Starts upgrading the firmware. ; NO*: Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/
Listening to the radio
Hold for about 2 seconds to memorize the current station.
• Press briefly to recall memorized station.
1 Press <!> SRC to select "TUNER."
2 Press BAND repeatedly to select
a
band (FM 1/ FM2/ FM3/ AM).
3 Press
~ 1 ~
to search for a station.
Adjust [SETTINGS] mode settings
While listening to the radio...
1 Press the volume knob to enter [FUNCTION] mode.
2 Turn the volume knob to select [SETTINGS], then press to enter.
3 Turn the volume knob to make a selection, then press to confirm.
See table below for selection.
4 Hold
~
to finish the procedure.
'::Jlf~;$f'~.
Selects the tuning mode for
~ I ~
buttons.
AUTOl *: Automatically search for astation. ; AUT02: Search in the order of the stations in the preset
memory. ; MANUAL: Manually search for astation.
AUTO MEMORY YES: Automatically starts memorizing 6stations with good reception. ; NO*: Cancels (automatic
_ _
~
not activated). (Selectable only if [NORM] is selected for [PRESET TYPE].) (page 6)
MONO SET
!
ON: Improve the FM reception (but the stereo effect may be lost).; OFF*: Cancels (stereo effect resumes).
Using the remote controller (RC-40S)
FM+ / AM- : Selects band.
~
1
~
(+) : Selects station.
1 - 6 : Selects preset station.
7