Sym AK12W Series Manual page 17

¡ } Checking front brake lining¡ ~
Check the brake from behind the brake caliper
The brake pad must be replaced with new lining
when the brake pad wear limit reaches the brake
disk.
¡ } Checking oil quantity in brake oil reservoir¡ ~
Park the motorcycle on a level ground, and check if
fluid level is under the "LOWER" mark.
Recommended Brake Fluid¡ G WELL RUN BRAKE
OIL (DOT 3).
¡ } Replenishment of front wheel brake fluid¡ ~
1. Loosen the screws and remove the master
cylinder cover.
2. Wipe clean foreign materials , dirt around the
reservoir, being careful not to let foreign
materials fall into the reservoir.
3. Remove the diaphragm plate and the
diaphragm.
4. Add brake fluid to upper level.
5. Install the diaphragm plate and the diaphragm,
and install the master cylinder cover.
6. Please note the diaphragm direction, and do
not let foreign materials fall into the reservoir.
And tighten the master cylinder cover securely.
CAUTION:
To prevent chemical reaction, please do not use brake fluids other than those recommended.
Do not fill above the upper limit when adding brake fluid and avoid dropping on painting or
plastic components to prevent damage.
Screw
Master cylinder cover
Diaphragm
Upper
17
Brake pad wear
limit grooves
Brake disk
Brake caliper
Brake fluid