Infinity COMPOSITIONSTM OVTR 1 Owner's Manual page 8

I
MPORTANT
I
MPORTANT
P
OWER
C P
HECKING LAYBACK
Figure 8. Located on each OVTR 1' s
rear panel are a BASS level control
and a dual-color "Power On" LED.
7 Compositions Overture OVTR 1 – Owner' s Manual
O
PERATING
For your convenience, the system is fitted with a power on/off switch. Once the system is
turned on, it will automatically go into a standby mode. Once an audio signal is present, the
system will automatically turn on. It will revert to standby (drawing only 7 watts) when audio is
absent for a minimum of 90 minutes. A dual-color "Power On" LED (see Figure 8 below) glows
red when the amplifier is in the standby mode and green when the amplifier is on.
If you plan to leave for an extended period of time (e.g., vacation), switch the system off
(or unplug the AC power cord).
!
This product is designed for (USA) 120 Vac use only. Do not connect it to any other
line voltages.
!
This product is fitted with a 3-prong grounded power cord. Do not use without ensuring the
outlet is grounded.
O ...
N
1. After speaker wiring has been completed, connect each speaker' s AC power cord to
the nearest AC receptacle. You should see an LED illuminate, indicating the amplifier is
on (see Figure 8 below). If not, verify the AC outlet is delivering power or refer to
Troubleshooting on page 9.
...
2. Check the speakers for playback by first setting the audio system volume control for a
minimum level, and then applying power to your system. Play a favorite music or video
segment and increase the volume control to a comfortable level.
NOTE: You should hear balanced audio reproduction across the entire frequency spectrum. If not,
check all wiring connections and refer to the "Troubleshooting" section on page 9 for more help.
OVTR 1
(rear view)
MAX
T S
HE YSTEM
MAX
More
Bass
BASS CONTROL
OVTR 1
MIN
ON /
– +
8
STANDBY
FUSE
BASS
INPUT
1.6A 250V
MIN
Less
Bass
ON / STANDBY
Power On
is green
"POWER ON" LED
OVTR 1
CAUTION:
FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE, REPLACE
ONLY WITH SAME TYPE OF FUSE:
2AG SB 250V
ATTENTION:
-230V 50Hz
UTILSER UN FUSIBLE DE RECHANGE
150W MAX DE MEME TYPE ET CALIBRE
Standby
is red