Infinity COMPOSITIONSTM OVTR 1 Owner's Manual page 7

3-way full-range bookshelf speakers
Hide thumbs Also See for COMPOSITIONSTM OVTR 1:
Table of Contents

Advertisement

T
O
A
URN
FF
LL
I
MPORTANT
I
MPORTANT
Figure 6. Compositions Overture
OVTR 1 speakers feature gold-plated
terminals that can be connected in
several different ways, e.g., spade terminals,
and direct wiring (as shown here).
Figure 7. Wiring diagram shows polarity
connections for one channel of a stereo or
home theater system.
W
IRING
P
...
OWER
After placing the speakers, you are ready to connect your system. First turn off all audio system
power. Use high-quality speaker wire to make your connections. For speaker connections, use
#18 gauge speaker wire (or #16 for runs over 25 feet) with polarity coding. The side of the wire
with a ridge or other coding is usually considered negative polarity (i.e., – ). Also, consult the
owner' s manuals that were included with your amplifier, receiver, or television to confirm
connection procedures.
!
If your system includes a Dolby
receiver, set the center-channel mode to NORMAL. This will route the low frequencies
(below 100Hz) away from the center-channel speaker to the front left and right speakers.
Observe polarities when making speaker connections, as shown in Figures 6 and 7 below.
Connect each + terminal on the back of the amplifier, receiver, or television to the respective
+ (red) terminal on each OVTR 1 speaker. Similarly, connect the (black) terminals in the same way.
!
Do not reverse polarities (i.e., + to - or - to +) when making connections. Doing so will cause
poor imaging and diminished bass response.
T
S
HE
YSTEM
®
Surround Pro Logic
OVTR 1
(rear view)
CONNECTING SPEAKERS DIRECTLY TO WIRES
Receiver or
Amplifier
(rear view)
+
(one channel shown)
®
®
or AC-3
preamplifier or A/V
+
Red =
Black =
OVTR 1
(rear view)
blk –
MAX
MIN
BASS
Compositions Overture OVTR 1 – Owner' s Manual 6
+ red
CAUTION:
FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE, REPLACE
ONLY WITH SAME TYPE OF FUSE:
2AG SB 250V
ON /
ATTENTION:
8
STANDBY
FUSE
-230V 50Hz
UTILSER UN FUSIBLE DE RECHANGE
INPUT
1.6A 250V
150W MAX
DE MEME TYPE ET CALIBRE

Advertisement

Table of Contents
loading

This manual is also suitable for:

Compositions overture ovtr 1

Table of Contents