Table of Contents
Advertisement
Several radio stations can be heard at the
same time.
Find a location and an orientation that provide
good reception, and then set up the antenna
again.
Bundle the antenna cables using commercially
available cord clips, for example, and adjust the
cable lengths.
DAB/DAB+ radio station is not received
properly.
Check all antenna connections, then perform
the DAB Automatic Scan procedure. See
"Running the DAB Automatic Scan manually
(CMT-SBT300WB only)" (page 53).
The current DAB/DAB+ service may not be
available.
Press TUNE +/– to select a different service.
If you have moved to another area, some
services/frequencies may have changed and
you may not be able to tune into your usual
broadcast. Perform the DAB Automatic Scan
procedure to re-register the contents of
broadcasts. (Performing this procedure clears
all previously stored presets.)
The DAB/DAB+ broadcast has been
interrupted.
Check the location of the system or adjust the
orientation of the antenna to increase the
indicated value of the signal quality.
Network connection
The system cannot connect to the network.
(Other equipment on the network cannot
find or recognize the system.)
Check that
is lit in the display .
It takes about 1 minute for the system to
acquire an IP address when the system is
turned on in a communication environment
without a router.
When you use a fixed IP address, the same IP
address may be used by other equipment. Use
a different IP address.
The system cannot connect to the network
via a wireless LAN connection.
If a network (LAN) cable is connected to the
system, the system automatically operates to
establish a wired LAN connection. If you wish to
use a wireless LAN connection, do not connect
a network (LAN) cable to the system.
Check the settings of the wireless LAN router/
access point. If the SSID stealth mode is set to
ON on the access point, set it to OFF. For details
on the settings of the access point, refer to the
operating manual for the access point.
The system cannot connect to the network
using WPS.
Set up your network after searching the access
point using the access point scan.
Update the firmware of the wireless LAN
router/access point to the latest version.
Music Services
The system cannot connect to Music
Services.
Make sure the wireless LAN router/access point
is turned on.
Check that
appears in the display window
. If not, set up a wireless network again
(page 34).
When the system is connected to a wireless
network, place the wireless LAN/access point
and the system closer together and perform
the setup again.
Depending on the providers, only one
connection to Internet is allowed. In that case,
the system cannot be connected if connection
is occupied. Please consult your carrier or
service provider.
When you turn on your mobile phone (Android
device, Xperia/Xperia Tablet, or iPhone/iPod
touch/iPad) after a moment of power off, try to
restart the "Network Audio Remote"
application.
65
GB
Hide quick links:
Advertisement
Table of Contents
