Remote Control - Panasonic SC-NE3 Operating Instructions Manual

Bluetooth
®
Pairing cannot be done.
≥ Check the Bluetooth
The device cannot be connected.
≥ The pairing of the device was unsuccessful or the registration has
been replaced. Try pairing the device again.
≥ This unit might be connected to a different device. Disconnect the
other device and try pairing the device again.
The device is connected but audio cannot be
heard through this unit.
≥ For some built-in Bluetooth
output to "SC-NE3" manually. Read the operating instructions for
the device for details.
The sound is interrupted.
≥ The device is out of the 10 m communication range. Bring the
Bluetooth device closer to this unit.
®
≥ Remove any obstacle between this unit and the device.
≥ Other devices that use the 2.4 GHz frequency band (wireless
router, microwaves, cordless phones, etc.) are interfering. Bring
the Bluetooth ® device closer to this unit and distance it from the
other devices.
≥ Select "MODE 1" for stable communication. (l 12)

Remote control

The remote control doesn't work properly.
≥ The remote control and this unit are using a different code.
(l right, "REMOTE ")
≥ Is the battery depleted or is the battery inserted incorrectly? (l 5)
16
16
VQT4X67
device condition.
®
devices, you have to set the audio
®
Messages
The following messages or service numbers
may appear on the unit's display.
"AUTO OFF"
≥ The unit has been left unused for about 30 minutes and will shut
down within a minute. Press any button to cancel it.
"DL ERROR"
≥ The software download has failed. Press any button to exit.
Please try again later.
≥ The server cannot be found. Press any button to exit. Make sure
that the wireless network is connected to the Internet.
"ERROR"
≥ Incorrect operation is performed. Read the instructions and try
again.
"F " (" " stands for a number.)
≥ There is a problem with this unit.
Note down the displayed number, disconnect the AC mains lead
and consult your dealer.
"FAIL"
≥ Updating or setting has failed. Read the instructions and try again.
"LEVEL 0"
≥ There is no link between this unit and the wireless network router.
Try the following operations:
– Check that the wireless network router is turned on.
– Turn this unit off and on again.
– Reset the wireless network settings. (l 7)
If the problem persists, consult your dealer.
"LEVEL j"
≥ When "D.CONNECT" is set to "ON" the Wi-Fi signal strength
cannot be checked. To check the Wi-Fi signal strength from the
wireless network router, set "D.CONNECT" to "OFF". (l 10)
"LINKING"
≥ This unit is communicating with the wireless network router
to complete the network settings.
Depending on the wireless network router this process may
take a few minutes. Try moving this unit closer to the wireless
network router.
"NOCONNECT"
≥ This unit is not connected to the network.
Check the network connection. (l 7)
"REMOTE " (" " stands for a number.)
≥ The remote control and this unit are using different codes. Change
the code on the remote control.
– When "REMOTE 1" is displayed, press and hold [OK] and
[ , AUX] for more than 4 seconds.
– When "REMOTE 2" is displayed, press and hold [OK] and
[SOUND] for more than 4 seconds.