Lubrication; Secondary Filter; Service - Hoover Compact Canister cleaner Owner's Manual

3-9
Place tab on bag door into slot in
lower front of cleaner. Close door.
NOTE: Cloth bag may be washed in
warm water. It must be thoroughly
dry before replacing it in the
cleaner.

Service

To obtain approved HOOVER ser-
vice and genuine HOOVER parts,
locate the nearest Hoover Factory
Service Center or Authorized
Hoover Warranty Service Dealer
(Depot) by:
• checking the Yellow Pages
under "Vacuum Cleaners -
Household" OR -
• checking the list of Factory
Service Centers provided with
this cleaner OR -
• calling 1-800-944-9200 for an
automated referral of
authorized service outlet
locations (U.S. only) OR -
• checking the Service section
of The Hoover Company online
at www.hoovercompany.com
Please do not send your cleaner to
The Hoover Company in North
Canton for service, this will only
result in delay.
3- 1 0

Secondary filter

Disconnect cleaner from electrical
outlet.
The secondary filter protects the
motor from dirt particles. It is
located on the back wall behind the
bag. When bag is removed, check
the filter (it is not removable).
Loosen dirt with a small brush and
wipe off dirt particles with a slightly
damp cloth. Dry thoroughly.
If further assistance is needed,
contact The Hoover Company
Consumer Response Center, North
Canton, Ohio 44720
Phone: 1-330-499-9499.
In Canada, contact Hoover Canada,
Burlington, Ontario L7R 4A8,
Phone: 1-800-263-6376.
Always identify your cleaner by the
complete model number when
requesting information or ordering
parts. (The model number appears
on the bottom of the cleaner.)
Rug and floor nozzle
To maintain the cleaning eff e c t i v e n e s s
of your rug and floor nozzle, the
brushes may need to be replaced
occasionally.
See your nearest Hoover Factory
Service Center or Authorized
Warranty Dealer (Depot) for
new brushes.

Lubrication

The motor is equipped with two
bearings that contain sufficient
lubrication for the life of the motor.
The addition of lubricant could cause
damage. There f o re, do not add
lubricant to either motor bearing.
7