Hoover SteanVac Owner's Manual page 4

8
Press cord into cord clip on back of handle.
Pull cord tight (Fig. 8).
Attach lower hose holder
HOSE
9
HOLDER
PROJECTIONS
With front of deep cleaner resting on floor, place 2 projections
on lower hose holder into 2 holes on back of cleaner (Fig 9).
10
Push screw into hole and tighten securely with a Phillips screw
driver (Fig 10).
Storing hose and nozzle on rack
NOZZLE CONNECTOR
11
END OF HOSE
CONVERTER
END OF HOSE
Stretch hose out and identify ends.
Note: You may find it helpful when storing the hose and nozzle
to refer to the information on the back of the deep cleaner
and on the converter end of the hose (Fig. 11).
4
Assembly
HOLES
TRIGGER
SOLUTION
HOSE
12
HANDLE
CLIP 1
CORD
HOOK
2
To store hose on rack, begin by placing nozzle connector end
of hose (straight end) into clip 1 on rack (Fig. 12).
13
1
4
2
3
Secure hose to rack at numbered locations as shown.
(Fig. 13)
14
EXTENSION
HOOK
Converter is stored in area as
shown.
While aligning arrows (Fig. 14), place extension into bottom of
converter opening; then push converter firmly against deep
cleaner until it snaps into place.
To remove, first pull top of converter off extension then pull off
bottom.
Secure solution hose to converter as shown.
NOZZLE
CONNECTOR
CLIP 1
2
ALIGN ARROW
& HOOK FOR
CONVERTER
STORAGE