Installation
The extractor is mounted to the wall using 6 plugs and fixing
screws, see figure 6.
1. Mark the wall with the positions of the fixing holes at
the required height. The height of the hood holes should
take into account the minimum height specified in the
instructions.
2. Fit 6 wall plugs appropriate for the wall type into the
drilled holes and fix two screws to the wall at positions 'A'
and leave approximately 5mm protruding.
3. Hang the hood and secure screws 'A'. Fix the hood in
position using 4 screws through the remaining mounting
holes shown.
Mounting the Chimney Section
1. Adjust the width of the mounting bracket to suit the
chimney size of your extractor and mark 2 points on the
wall, 20mm down from the ceiling for the fixings (fig 7).
2. Drill and insert 2 plugs suitable for use with the wall type
into the holes and fix the bracket with 2 screws.
3. Fit the chimney section and secure to the mounting
bracket with the supplied screws (fig 8).
11 7.5
101.5
7
A
A
271
Fig. 6
Fig. 7
Fig. 8
318
57
9