Lubrication; Service - Hoover Corded & Cordless Rechargeable Instructions Manual

17
Remove handle from top of motor
housing, then remove dirt cup.
Cut data label along seam on
17
back of motor housing.
20
Disconnect the two wires from
20
battery terminals.
Dispose of battery pack in accor-
dance with you state's laws.
Your local area may have a recycling
center or collection system for dispos-
al of Ni-Cd batteries.
For information please call
1-800-8-BATTERY
6
18
Remove 5 screws from motor
18
housing as shown.
Pull motor assembly from housing.
Remove tape from battery pack.

Service

To obtain approved Hoover Service
and Genuine HOOVER parts, locate
the nearest Hoover Factory Service
Center or Authorized Hoover
Warranty Service Dealer (Depot) by:
• checking the Yellow Pages
under "Vacuum Cleaners-
Household"
• checking the list of Factory
Service Centers provided with this
cleaner OR-
• calling 1-800-944-9200 for an auto-
mated referral of authorized service out-
let location (U.S. only).
Do not send your cleaner to The
Hoover Company in North Canton
for service, this will only result in
delay.
If further assistance is needed, con-
tact The Hoover Company
Consumer Response Center, North
Canton, Ohio 44720, Phone: 1-330-
499-9499.
In Canada, contact Hoover Canada,
Burlington, Ontario L7R 4A8, Phone:
1-800-263-6376.
Always identify your cleaner by the
complete model number when
requesting information or ordering
parts. (The model number appears
on the back of the motor housing.)
19
Slide battery pack out of
19
holders.

Lubrication

Lubrication is not necessary since
the motor and brush roll bearings
are permanently lubricated.