1. Manuals
  2. Brands
  3. AEG Manuals
  4. Washer
  5. L 87680 FL
  6. User manual

AEG L 87680 FL User Manual

Hide thumbs Also See for L 87680 FL:
Table of Contents

Advertisement

Quick Links

Download this manual
EN User manual
L 87680 FL

Advertisement

Table of Contents
loading

Related Manuals for AEG L 87680 FL

Summary of Contents for AEG L 87680 FL

  • Page 1 EN User manual L 87680 FL...

  • Page 2: Table Of Contents

    19. ENVIRONMENT CONCERNS ..........32 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler –...

  • Page 3: Safety Information

    ENGLISH SAFETY INFORMATION Before the installation and use, read this manual carefully: • For your safety and the safety of your property • To help the environment • For the correct operation of the appli- ance. Always keep these instructions with the appliance also if you move or give it to a 1.3 General safety different person.

  • Page 4: Technical Information

    • Do not install and connect a damaged Electrical connection appliance. • Make sure that the appliance is earth- • Make sure to remove all packaging and transport bolts. • Make sure that the electrical informa- • Make sure that the mains plug is dis-...

  • Page 5: Product Description

    ENGLISH Water supply pressure Minimum 0,5 bar (0,05 MPa) Maximum 8 bar (0,8 MPa) Cold water Water supply Maximum load Cotton 8 kg Spin speed Maximum 1600 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 3.

  • Page 6: Accessories

    4. ACCESSORIES Spanner To remove the transit bolts. Plastic caps To close the holes on the rear side of the cabinet after the removal of the transit bolts. Anti-flood inlet hose To prevent possible leakage Plastic hose guide To connect the drain hose on the edge of a sink.

  • Page 7: Programme Knob

    ENGLISH – Set again the washing programme 6.1 AUTO Off button and all possible options. Press this button to activate or deacti- • After 5 minutes from the end of the vate the appliance. A tune sounds when washing programme. Refer to 'At the the appliance is activated.
  • Page 8 The phase symbols • When a programme is set, all the symbols of the phases related to the programme come on. • When the programme starts, only the symbol of the phase in oper- ation flashes. • When the programme is completed, the symbol of the last phase is on.

  • Page 9: Delay Start Button

    ENGLISH If you make a wrong selection the message Err indicates that the selec- tion is not possible. The time save symbol comes on when you set one of the programme duration: • Shortened duration • Extra Quick The extra rinse symbol comes on when this function is acti- vated.

  • Page 10: Permanent Extra Rinse

    10 www.aeg.com when you have laundry with a high lev- If you deactivate the acoustic sig- el of soil. nals, they continue operate only when you press the buttons and The set of this function increases when a malfunction occurs.

  • Page 11: Programmes

    ENGLISH 7. PROGRAMMES Programme Type of load Cycle Functions Temperature Max. weight of load descrip- tion Aðalþvottur White and coloured cotton Wash SPIN REDUC- 95° - Cold with normal soil. Rinses TION max. load 8 kg Long RINSE HOLD spin PREWASH EXTRA RINSE STAIN...
  • Page 12 12 www.aeg.com Programme Type of load Cycle Functions Temperature Max. weight of load descrip- tion Ofnæmisvörn White cotton items. Wash SPIN REDUC- 60° This programme removes mi- Rinses TION cro-organisms thanks to the Short RINSE HOLD washing by 60° C and adds...

  • Page 13: Consumption Values

    ENGLISH 3) If you set the Extra Quick duration, we recommend that you reduce the maximum load. It is possible to load fully the appliance, however the washing results are reduced. 4) The wash and spin phase is soft to prevent the creases of the laundry. The appliance adds some rinses.

  • Page 14: Before First Use

    °C cotton 1) At the end of spin phase. Model Off Mode (W) Left On Mode (W) L 87680 FL 0.05 0.05 9. BEFORE FIRST USE To activate the drain system, put 2 li- detergent dispenser. Set and start a...

  • Page 15: Loading The Laundry

    ENGLISH 11. LOADING THE LAUNDRY Open the appliance door. Make sure not to put too much laun- dry in the drum. Put the laundry in the drum, one item at a time. Shake the items be- Close the door. fore you put them in the appliance. Make sure that no laundry stays between the seal and the door.

  • Page 16: Check The Position Of The Flap

    16 www.aeg.com This is the maximum level for the quantity of liquid additives. The compartment for the stain remover. Put the product in the compartment and set the stain function before you start the programme. Flap for powder or liquid detergent Turn it (up or down) in the correct position to use powder or liq- uid detergent.

  • Page 17: Setting And Starting A Programme

    ENGLISH Measure out the detergent and the fabric conditioner. Carefully close the detergent dis- penser. Make sure that the flap does not cause a blockage when you close the drawer. 13. SETTING AND STARTING A PROGRAMME Turn the programme knob. The rela- 13.2 Cancel a programme ted programme indicator comes on.

  • Page 18: At The End Of The Programme

    18 www.aeg.com 13.5 Cancel the delay start Close the appliance door and press button . The programme or the Press button . The related indica- delay start continues. tor flashes. If the temperature and level of Press button again and again un- the water in the drum are too til the display shows 0’.

  • Page 19: Hints And Tips

    ENGLISH 15. HINTS AND TIPS 15.1 The laundry load 15.3 Detergents and additives • Divide the laundry in: white, coloured, • Only use detergents and additives synthetics, delicates and wool. specially made for washing machines. • Obey the washing instructions that are •...

  • Page 20: Care And Cleaning

    20 www.aeg.com Water hardness table Water hardness Level Type °dH °T.H. mmol/l Clarke soft 0-15 0-1.5 medium 8-14 16-25 1.6-2.5 10-16 hard 15-21 26-37 2.6-3.7 17-25 very hard > 21 > 37 >3.7 >25 16. CARE AND CLEANING WARNING! CAUTION! Do not use alcohol, solvents or chemical products.

  • Page 21: Detergent Dispenser

    ENGLISH 16.6 Detergent dispenser To clean the dispenser: Press the lever. Pull the dispenser out. Remove the top part of the liquid additive compartment. Clean all the parts with water. Clean the dispenser recess with a brush. Put back the dispenser in the recess. •...
  • Page 22 22 www.aeg.com To clean the drain pump: Open the drain pump door. Pull the flap out to remove it. Put a container below the recess of the drain pump to collect the water that flows out. Press the two levers and pull for- ward the drainage duct to let the water flow out.

  • Page 23: Emergency Drain

    ENGLISH Clean the filter under the water tap and put it back in the pump into the special guides. Make sure that you tighten correctly the filter to prevent leakages. Put the flap back and close the drain pump door. 16.8 The inlet hose filter and •...

  • Page 24: Troubleshooting

    24 www.aeg.com Put the drainage duct back and close the Close the water tap. drain pump flap. Remove the water inlet hose When you drain the water with the emer- Put the two ends of the inlet hose in gency drain procedure, you must acti-...
  • Page 25 ENGLISH Problem Possible cause Possible solution The appliance The water drain hose is Make sure that the water drain does not drain the damaged. hose has no damages. water. The filter of the drain Clean the filter of the drain pump is blocked.

  • Page 26: Installation

    26 www.aeg.com Problem Possible cause Possible solution Leakages from the drain Make sure that the drain pump pump. filter is tight. The water drain hose is Make sure that the water inlet damaged. hose has no damages. You cannot open...
  • Page 27 ENGLISH 18.2 Unpacking Use the gloves. Remove the external film. If necessary, use a cutter. Remove the cardboard top. Remove the polystyrene packaging materials. Remove the internal film. Open the door. Remove the poly- styrene piece from the door seal and all the items from the drum.
  • Page 28 28 www.aeg.com Put one of the polystyrene packag- ing elements on the floor behind the appliance. Carefully put down the appliance with the rear side on it. Make sure not to damage the ho- ses. Remove the polystyrene protection from the bottom.

  • Page 29: Positioning And Levelling

    ENGLISH Put the plastic caps in the holes. You can find these caps in the user manual bag. WARNING! We recommend that you keep Remove all the packaging and the packaging and the transit the transit bolts before you install bolts for when you move the ap- the appliance.

  • Page 30: Water Drainage

    30 www.aeg.com 18.4 The inlet hose • Connect the hose to the appliance. Turn the inlet hose only left or right. Loose the ring nut to set it in the cor- rect position. • Connect the water inlet hose to the cold water tap with 3/4 thread.
  • Page 31 ENGLISH With the plastic hose guide. • On the edge of a sink. • Make sure that the plastic guide can- not move when the appliance drains. Attach the guide to the water tap or the wall. • To a stand pipe with vent-hole. Refer to the illustration.

  • Page 32: Environment Concerns

    32 www.aeg.com You can extend the drain hose to maximum 400 cm. Contact the service centre for the other drain hose and the extension. 19. ENVIRONMENT CONCERNS Recycle the materials with the appliances. Do not dispose symbol . Put the packaging in appliances marked with the symbol applicable containers to recycle it.
  • Page 33 ENGLISH...
  • Page 34 34 www.aeg.com...
  • Page 35 ENGLISH...
  • Page 36 www.aeg.com/shop...

Table of Contents