Park Brake Lever - Polaris Ranger 4X4 Owner's Manual

Park Brake Lever

To help prevent the vehicle from rolling, engage the park brake when
parking the vehicle. When the park brake is fully engaged and the park
brake indicator is illuminated, engine speed is limited to 1300 RPM in
all gears, except neutral. If throttle is applied, this limiting feature pre-
vents operation, which protects the park brake pads from excessive
wear.
Tip: This feature will not operate properly if the park brake connector or switch
(under the hood) malfunctions or becomes disconnected, or if the switch
has moved. Check for disconnection, then see your dealer promptly if this
feature fails to operate properly.
Inspect and adjust park brake cable tension after the first 25 hours of
operation and every 100 hours thereafter to ensure proper cable tension.
See page 80.
Always apply the service brakes
before engaging or releasing the
park brake.
1. Apply the brakes.
2. Pull the park brake lever
downward as far as possible.
3. To release the park brake,
apply the brakes. Press the
park brake release inward and
move the lever upward as far
as possible.
WARNING! Operating the vehicle while the park brake is engaged could cause
loss of control and result in serious injury or death. Always disengage the park
brake before operating the vehicle.
FEATURES AND CONTROLS
25