Life Fitness Platinum Club Series Assembly Instructions Manual page 7

Life fitness platinum club series treadmills
Hide thumbs Also See for Platinum Club Series:
Table of Contents

Advertisement

26.
Remove the protective backing from the four HOOK AND LOOP FASTENERS (S) located on the back of the LEFT
SIDE EXTRUSION (31). Align the LEFT SIDE EXTRUSION with the channel in the LEFT SIDERAIL (T) and REAR
ENDCAP (29) as shown. Tilt and engage the LEFT SIDE EXTRUSION to the LEFT SIDERAIL. Press firmly on the
underside of the LEFT SIDE EXTRUSION to secure the HOOK AND LOOP FASTENERS to the frame.
Install one FOAM STRIP (32) between the SIDE RAIL and LEFT SIDE EXTRUSION.
Repeat to install the RIGHT SIDE EXTRUSION (33) to the RIGHT SIDERAIL (U).
NOTE: BE SURE THE TREADMILL IS IN THE FINAL LOCATION FOR USE BEFORE INSTALLING THE LEFT
AND RIGHT EXTRUSIONS.
27.
Install the LEFT (34) and RIGHT (35) UPRIGHT COVERS using two SCREWS (30) and one SCREWS (36) each.
Tighten the SCREWS securely. Do not overtighten the SCREWS.
Press inward on the UPRIGHT COVER and engage the pre-installed SCREW (V) located at the rear of each
UPRIGHT COVER.
28.
Reinstall the MOTOR COVER (B) using the six previously removed SCREWS (A). Tighten the SCREWS securely.
Do not overtighten the SCREWS.
29.
Install the GROMMETS (37) into the screw holes of the INNER HANDRAIL COVERS.
30.
Install the CUP HOLDERS (38).
NOTE: BE SURE THE TABS ENGAGE FIRST AND TILT INTO PLACE.
31
The treadmill striding belt must be "walked-in" for five minutes after assembly is complete.
Plug the treadmill into an appropriate outlet. Turn the treadmill on at the on/off switch. Select QUICK START from
the console. Increase the speed to 3 mph (4.8 km/h). Start walking in the front left corner of the walking surface
and drift to the back, move to the center of the deck and walk towards the front, and finally walking to the right
corner and drifting to the back. Continue pattern for five minutes.
32.
Refer to the Operation Manual for power requirements, proper line cord routing, and other critical product informa-
tion before connecting the treadmill to a power source. A digital version of the Operation Manual can be found on
the attached CD.
35
30
B
4
1
V
36
A
28
30
U
S
31
30
29
30
T
32
34

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

95t

Table of Contents