Alignment Procedure - Daewoo 719B Service Manual

ALIGNMENT PROCEDURE

Standard Adjustment Conditions
1. Power source voltage : AC 120V, 60Hz/AC 220V, 50Hz.
2. Aging : Take at least 20 minutes warm-up time.
3. Signals.
Video : Analog 0.7Vpp 75Ω terminal positive polarity
Synchronizing : TTL Level Negative/Positive Separate/Composite
Deflection frequency
Horizontal Frequency : 30KHz - 70KHz
Vertical Frequency : 50Hz - 160Hz
Pre-Adjustment
1. High Voltage Adjustment
Adjust 26K Vdc between Anode cap and ground at a cross hatch pattern of 60KHz by using VR 502.
Method to launch the factory mode
Step 1. Push the menu button.
Step 2. Push the menu button and Brightness minus control button (
Main Adjustment
1. Setting the Controls
Set the value of items as following.
Contrast : Max. (OSD value up to 100)
Brightness : Center (Set the OSD value to 50)
2. H.size, V.size, H.phase, V.position, Pincushion, Trapezoid
Receive the cross hatch pattern of Factory preset mode.
H.size, V.size, H.phase, V.position, Pincushion, Trapezoid are adjusted at each mode.
In Factory, Auto Alignment was done at each mode. Therefore, Factory preset mode has it's own value
according to each control.
3. Focus
(a) Set brightness control to center and contrast control to MAX.
(b) Receive all "H" character pattern of 60KHz mode signal.
(c) Adjust the Focus control of FBT to obtain best Focus (static focus and Dynamic focus).
4. Geometric Distortion Adjustment
(a) Receive the cross hatch pattern of VGA mode signal by using the signal generator.
(b) Pin balance, Parallelogram are adjusted the best geometric status.
(c) Repeat the adjustment at each mode.
5. White Balance Adjustment
(a) Receive a full white pattern of 60KHz mode.
(b) Set the bright control and contrast control to the maximum and receive the all black pattern.
(c) Select a Temperature function on the R, G, B item of the OSD menu and select 9300.
(d) If the screen luminosity is changed, adjust the sub brightness control to get the 0.6 ~ 0.8 Ft/L screen
luminosity.
(e) Select the R, G, B Bias on the OSD menu and adjust the
X=0.281, Y=0.311.
(f) Set the brightness control to the center and contrast control to the maximum.
(g) Receive a full white pattern.
) for 5 times in same time.
/ key to get the color coordinates in
15