Alignment Procedure - Daewoo 720D Service Manual

ALIGNMENT PROCEDURE

Standard Adjustment Conditions
1. Power source voltage : AC 100 - 240Vac, 50/60Hz.
2. Aging : Take at least 15 minutes warm-up time.
3. Signals.
Video : Analog 0.7Vpp 75Ω terminal positive polarity
Synchronizing : Composite H+V Sync : 1.0Vpp ~ 5.0Vpp (Positive / Negative)
Separate H, V Sync : TTL Level (Positive / Negative)
Deflection frequency
Horizontal Frequency : 30KHz - 95KHz
Vertical Frequency : 50Hz - 160Hz
Main Adjustment
1. Setting the Controls
Set contrast and brightness in Control Menu unless otherwise specified.
Contrast : Max.
Brightness : Center
2. H. Size, H. Center, V. Size, H. Center, Side Pincushion, T. Pin Corner, B. Pin Corner, Trapezoid,
Parallelogram, Rotation, Pin Balance, H. Linearity, V. Linearity
Receive the cross hatch pattern of Factory preset mode.
H. Size, H. Center, V. Size, H. Center, Side Pincushion, T. Pin Corner, B. Pin Corner, Trapezoid,
Parallelogram, Rotation, Pin Balance, H. Linearity, V. Linearity controls are adjusted at each mode.
In Factory, Auto Alignment was done at each mode. Therefore, Factory preset mode have their own
value according to each control.
3. Focus
(a) Set brightness control to center and contrast control to Maximum.
(b) Receive all "H" character pattern of 91KHz mode signal.
(c) Adjust the Static Focus VR to obtain best H.Focus.
(d) Adjust the Dynamic Focus VR to obtain best V.Focus.
(e) If the H/V Focus is not satisfactory, readjust the Static / Dynamic Focus.
4. White Balance Adjustment
(a) Select 9300°K on the OSD Menu.
(b) Receive a full white pattern of 91KHz mode signal by using the signal generator.
(c) Set the brightness control to 80 and the contrast control to maximum.
(d) Cut off the HVG screen VR.
(e) Receive all the black patterns. The luminance of the screen should be 0.2 ± 0.03 Ft-L by using
Screen VR.
(f) Select the R-BIAS, G-BIAS and B-BIAS on the control menu and adjust the
color coordinates in x=0.281 ± 0.015, y=0.311± 0.015.
(g) Receive a small block pattern. Adjust the brightness value to the center.
(h) Select the R-GAIN and B-GAIN and adjust the
0.015, y=0.311 ± 0.015.
(i) Adjust the ABL(at the OSD) control to get the screen luminance to 40 Ft/L (a small block pattern).
(j) Receive a full white pattern. Adjust VR581(Sub-contrast) to get the screen luminance to 30 Ft-L.
Check if the x, y coordinates of color analyzer is in x=0.281±0.015, y=0.311±0.015. If the color
coordinates is out of range, adjust the R. G. B BIAS & GAIN to get the coorinates in x=0.281,
y=0.311. Make sure that the coordinates is in the appropriate range.
(k) Select 6550°K on the OSD Menu and set the color coordinates in x=0.313, y=0.329 at the
maximum contrast control and center brightness control
(l) Check if a full white pattern is over 30Ft/L.
All manuals and user guides at all-guides.com
13
/ key to get the color coordinates in x=0.281 ±
/ key to get the