Prepare The Installation; Install Backsplash; Install Wood Mounting Strip; Install The Hood - Rangemaster RM60000 SERIES Installation Instructions And User Manual

3. PREPARE THE INSTALLATION

Remove the installation kit from inside the hood.
Make sure that the following items are included:
-Wood strip
-Installation manual
-Accessories including:
.Filters (Quantity varies depending on range hood width)
.Bag of parts including:
Screws 10-2" flat head (4),Screws
#
Wall anchors (2), Washers 3/16" ID X 3/4" OD (2)
Using a Phillips #2 or a Robertson #2 screwdriver, unscrew the hood
from the bottom of crate. Refer to figure beside to locate all 4 screws.
Discard these screws and remove hood from wood pallet.

4. INSTALL BACKSPLASH

(OPTIONAL) RMP Series
Backsplash must be installed before the hood shell because the hood shell covers the backsplash top mounting screws. In order to be
able to install the backsplash, make sure you have at least 18" (457 mm) clearance between bottom of hood and range control panel or
cooktop. (Refer to instructions included with backsplash.)

5. INSTALL WOOD MOUNTING STRIP

Measure and mark a level line on wall above cooktop location for the wood
mounting strip (see illustration below and under step 2). Use #10 - 2" flat
head screws to secure the mounting strip to the drywall. Make sure to
hit the wall studs. (See figure beside.)
Due to the weight of this hood, ensure that the wood strip is
attached to all of the available wall studs (2 studs minimum for
the 30" hood, more as hood width increases); not into the drywall
alone.

6. INSTALL THE HOOD

Rest the back cavity of the hood on the wood mounting strip.
Hold the hood until it is completely secured to the wood
mounting strip.
Secure hood to wood strip with (4) screws #8 - 3/4" (for 30" and 36"
width hoods) or (6) screws (for 42" width and wider hoods) provided at
locations shown. Drill (2) 3/16" size holes into the drywall for wall
anchors through the existing holes in the inside hood back in the loca-
tions shown. Then install the two wall anchors and attach the hood to
these anchors with the remaining #8 - 3/4" screws and the (2) washers
provided.
8-3/4" (8), Nuts
#
CAUTION
CAUTION
10-32 (4)
#
HR0002
1. Drywall
2. Wood Mounting Strip
3. Flat Head Screw
HD0064
- 6 -
3 4
1
2
4. Wall Anchor Location
5. Outline of the Back of the Hood
6. Wall Studs
Top of hood (inside view)
Mounting Screw Locations
Back of hood (inside view)
Wall Anchor Locations
5