Chevrolet 2004 Avalanche Getting To Knowow page 7

Program radio station presets
• Turn the radio on.
• Press BAND to select the band (AM,
FM1/FM2/XM1/XM2).
• Use the seek or tune knob to tune in
the desired station.
• Press AUTO EQ or AUTO TONE (as
applicable to your radio) to select the
equalization that best suits the type of
station selected.
• Press and hold one of the six num-
bered buttons until a beep sounds;
release the button.
• Repeat these steps for each station
preset, using a different numbered
button for each station.
Access one of the two available XM
Satellite Radio bands (if equipped)
• Press the BAND button until XM1 or
XM2 appears on the display. Note:
Requires subscription to XM Radio.
Six-Disc CD Changer (if equipped)
Load 1 CD
• With the ignition on, press and
release the LOAD side of the LOAD
CD button.
• Wait for the green indicator light at
the right side of the slot to turn green.
• Insert the disc partway into the slot,
label side up; the player will pull the
disc in.
Load multiple CDs
• With the ignition on, press and hold
the LOAD button for two seconds.
The unit beeps and the light to the
right of the slot begins to flash.
• When the light stops flashing and
turns green, insert a disc partway,
label side up.
• The indicator light will begin blinking
and turn steadily green. Load another
disc at this time.
• When loading more than one but
fewer than six CDs, press the LOAD
button again to signal that loading is
complete.
• When more than one disc is loaded,
a number for each disc is displayed.
• To play a specific CD, press the CD
AUX button and then the number of
the CD you want to hear.
• A small bar appears under the CD
number that is playing, and the track
number appears.
Note: If equipped with Navigation
Radio, see your Owner Manual or
Navigation Radio guide for operating
instructions.
See Section 3 of your Owner Manual.
7