Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for DieHard 28.71495
Summary of Contents for DieHard 28.71495
- Page 1 OPERATOR’S MANUAL 750 Watt Power Inverter Model No. 28.71495 Read and follow all Safety Rules and Operating Instructions before Every Use of this Product. SAvE ThESE INSTRUcTIONS. Sears Brands Management corporation, hoffman Estates, IL 60179 U.S.A. 00-99-001006/00...
-
Page 3: Table Of Contents
1 year from the date of purchase, return it to any DieHard outlet in the United States for free replacement. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. - Page 4 IMPORTANT: READ AND SAvE ThIS SAfETY AND INSTRUcTION MANUAL. SAvE ThESE INSTRUcTIONS – The 71495 offers a wide range of features to accommodate your needs. This manual will show you how to use your inverter safely and effectively. Please read, understand and follow these instructions and precautions carefully, as this manual contains important safety and operating instructions.
-
Page 5: Important Safety Instructions
IMPORTANT SAfETY INSTRUcTIONS SAvE ThESE INSTRUcTIONS Risk of electric shock or fire. Keep out of reach of children. Keep the inverter well ventilated in order to properly disperse heat generated while it is in use. Make sure there are several inches of clearance around the top and sides and do not block the slots of the inverter. -
Page 6: Features
fEATURES Battery Clips 12 Volt Power Plug Digital Display LED Display On/Off and Display Switch AC Outlets BEfORE USINg YOUR POWER INvERTER NOTE: This inverter is designed to be used with a single battery, up to group 31 type and 130 Ah or smaller in size. Do not use with any larger battery type. Do not use with multiple batteries connected in parallel. - Page 7 The wattage (WATTS) or amperes (AMPS) can normally be found stamped or printed on most devices and equipment, or in the user’s manual. Otherwise, contact the manufacturer to find out whether the device you want to use is compatible with a modified sine wave.
-
Page 8: Connecting Inverter Cables
Transformerless Battery Chargers. Doing so, may cause the device to run warmer or overheat. cONNEcTINg INvERTER cABLES The inverter and power source must be in the OFF mode. Make sure you connect your inverter to a 12-volt power supply only. Inverter connection: Decide whether you want to use the 12 volt power plug (100 watts maximum) or the battery clamps (full inverter capacity). -
Page 9: Operating Instructions
connecting inverter cables to 12v battery or 12v power source: NEgATIvE gROUNDED SYSTEM Keep hands, hair, clothing and jewelry clear of battery terminals. Wear eye protection and clothing protection. Connect the positive (red) inverter terminal cable to the power source positive (+) or battery terminal. - Page 10 NOTE: If more than one device is to be powered, start one device at a time to avoid a power surge and overloading the inverter. The surge load of each device should not exceed the inverters Continuous Operation wattage rate. If there is a short circuit or power surge in the device, ...
-
Page 11: Power Source
POWER SOURcE Your average automobile or marine battery at full charge will provide an ample power supply to the inverter for approximately 3 hours when the engine is off. The actual length of time the inverter will function depends on the age and condition of the battery and the power demand being placed by the device being operated with the inverter. -
Page 12: If The Inverter Fuse Blows
If ThE INvERTER fUSE BLOWS Your power inverter is fitted with a fuse, which should not have to be replaced under normal operating conditions. A blown fuse is usually caused by reverse polarity or a short circuit within the device or equipment being operated. If the fuse does blow, take the inverter to a qualified technician for repair. - Page 13 PROBLEM REASON SOLUTION Alarm is On (Continued) Display shows . Inverter Increase the ventilation to the is too hot. inverter. Move the inverter to a cooler area. Reduce the power consumption of the device. The inverter will automatically reset after cooling. Inverter does not turn on.
-
Page 14: Specifications
SPEcIfIcATIONS Maximum Continuous Power 750 Watts Surge Capacity (Output Wattage) 1500 Watts No Load Current Draw <0.6 Amps Wave Form Modified Sine Wave Input Voltage Range 10.5 - 15.5V DC Low Battery Alarm 10.7V - 11.3V DC Output Voltage 110V - 125V AC Low Battery Shutdown 10.2V - 10.8V DC High Battery Shutdown...