Advertisement
12
Wind the coil cable around the lower
and middle shaft enough times to take
up the slack.
Use the velcro tabs to keep the coil cable
in place against the shaft. It is recommended
that one tab is used on the lower shaft close
to the coil and the other tab on the middle
shaft before the cable reaches across to
the control box.
Align the coil plug and connect into
the socket in the back of the control box,
lightly tightening the retaining ring to
hold it in place.
The X-Terra uses 4
AA batteries which
X
are not included with the detector.
(Battery
Behaviour, pg. 62)
Access the battery compartment via the
battery door located on the side of the
control box. Slide the battery compartment
door upwards with your thumb.
Place individual batteries into the
compartment as illustrated, ensuring
+
–
the positive (
) and negative (
) contacts
match the diagram on the control box.
Close the battery door by pushing and
sliding it downwards.
If the detector does not turn on check the
battery orientation. The detector will not
be damaged if the batteries are inserted
incorrectly.
13
Advertisement
