Door Disassembly For Swing Type Models; Remove Swing Refrigerator And Freezer Doors - Kenmore 795.7620 Service Manual

3-8 DOOR DISASSEMBLY
FOR SWING TYPE MODELS
3-8-1 REMOVE SWING REFRIGERATOR
AND FREEZER DOORS
Before removing the doors, remove the Base Grille.
screwdriver and remove.
Fig. 66
Using 10mm or 13/32-inch socket wrench, remove
the 3 bolts and lift off the T op Hinge. Set parts aside.
Fig. 67
Lift up door slightly and remove it. Place door on
a non scratching surface.
Fig. 68
Hinge Pin
Remove washer and set aside.
Using a 1/4 socket wrench, loosen and remove
Hinge Pin from the Middle Hinge Bracket.
Use a 10mm or 13/32 inch socket wrench to remove
the 2 bolts in Middle Hinge Bracket. Remove
screws. Set Middle Hinge Bracket and other parts
aside.
Fig. 21
Middle Hinge
Bracket
Bolts
Fig. 69
Carefully lift up the freezer door. Remove and place
it on a non-scratching surface.
Using a 13/32" 10mm socket wrench with a
2" extension, loosen the 2 bolts and remove
Bottom Hinge Bracket from right side.
Bottom Hinge Pin
Bottom Hinge
Bracket
- 17 -
Screws
(2)
Washer
Middle
Hinge Pin
Fig. 70