Starting Cold Engine - Echo EDR-260 Operator's Manual

Engine drill
Hide thumbs Also See for EDR-260:
Table of Contents

Advertisement

Shoulder level
Throttle trigger
Push
Purge bulb
Choke lever
Fuel tank
ON
Ignition switch
STOP
Throttle trigger lockout
Starter handle
Fuel return line
START
(Close)
RUN
(Open)
IMPORTANT
Stored fuel ages. Do not mix more fuel than
you expect to use in thirty (30) days, ninety
(90) days when a fuel stabilizer is added.
Stored two-stroke fuel may separate.
ALWAYS shake fuel container thoroughly
before each use.

STARTING COLD ENGINE

WARNING
• WHEN ENGINE IS STARTED, CONFIRM IF
THERE IS NOT ANY ABNORMAL
VIBRATION OR SOUND. IF THERE IS
ABNORMAL VIBRATION OR SOUND, ASK
YOUR DEALER TO REPAIR.
• AFTER REFUELING, TIGHTEN FUEL CAP
FIRMLY AND CHECK FOR LEAKAGE. IN
CASE OF FUEL LEAKAGE, REPAIR
BEFORE STARTING OPERATION SINCE
THERE IS A DANGER OF FIRE.
It is not permitted to fill fuel above the shoulder
level of fuel tank.
Stand the engine upright on a level surface.
Place ignition switch in ON (START/RUN)
position.
Push purge bulb 3 to 4 times (or until fuel is
visible in fuel return line).
Shift choke lever to close position (START).
Pull starter handle until the engine fires.
Shift choke lever to full open position, and if
necessary, start the engine again and allow to
warm up before using.
- The clutch engages at approximately 3,500
r/min. Therefore the drill bit may rotate at fast
idle engine speed.
8
DANGER

Advertisement

Table of Contents
loading

Table of Contents