Time Program; Operating Mode - Honeywell Heating Controller SDC Operating Instructions Manual

Operation
4.2.3.2
Set values
Factory setting
Effects
4.2.3.3
Setting range
Set values
Factory setting
52

Time program

This parameter specifies enabling of the switching time programs
for program selection and for individualised switching time
programming. In the state of delivery, only one switching time
program is enabled. This achieves simplification of operation with
a large portion of applications for which only one switching time
program is used.
P1 Program 1 = enabled, programs 2 and 3 = disabled
P1 All three programs enabled
to P3
P1
In contrast to the previous description, the following setting
options are available when programs P1 to P3 are enabled:
• Operating mode selection: In the AUTOMATIC and SUMMER
operating modes, switching time program P1, P2 or P3 can be
selected.
• Switching time programming: With switching time pro-
gramming, the three switching time programs, P1 to P3, can
be selected for each heating circuit.
Pos: 46 /156-Honeywell/Bedienung/Bedienmodus @ 1\m od_1207646570291_6.doc @ 9840

Operating mode

Two operating modes can be selected. They determine whether
the operating mode, the daytime temperature and the night-time
temperature apply for all heating circuits or can be specified
individually for each heating circuit.
1, 2
1 The selected setting applies for all heating circuits together.
2 Each heating circuit can be assigned an individualised set-
ting.
1
Pos: 47 /156-Honeywell/Bedienung/Individuelle_Tages-Raumtemperatur @ 1\m od_1207646601885_6.doc @ 9855
SDC / DHC
EN2H-0220GE51 R1111