Honeywell Heating Controller SDC Operating Instructions Manual page 37

SDC / DHC
NOTE
4.2.2.4.3
EN2H-0220GE51 R1111
The switch-off time cannot be set higher than the switch-on time
of a subsequent cycle.
If the switch-on time is changed, the corresponding time bar
display is adjusted to the right-hand side.
If the switch-off time is made equal to the switch-on time, the
corresponding cycle is deleted. A subsequent cycle is
automatically shifted to the position of the deleted cycle upon
acceptance.
With subsequent insertion of a cycle that has been bumped up,
the corresponding day of the week must be reprogrammed.
A flashing switch-off time is accepted by pressing the input button
Pos: 35 /156-Honeywell/Bedienung/Zyklustemperatur @ 1\mod_1207645359213_6.doc @ 9645
Cycle temperature
Once the switch-off time is accepted, the associated cycle
temperature appears flashing and can be changed immediately
with the input button
temperature is always based on the desired room temperature;
with the hot-water circuit, it is based on the desired normal hot-
water temperature in the selected cycle.
A flashing cycle temperature is accepted by pressing the input
î
button .
At the same time, the last called-up cycle appears flashing so that
it may be monitored; additional cycles can then be selected
directly and edited in the same way in the order: switch-on time,
switch-off time, cycle temperature.
Pos: 36 /156-Honeywell/Bedienung/Schaltzeitenprogramm ierung_gesperrt @ 1\m od_1207645477385_6.doc @ 9660
î . With heating circuits, the displayed cycle
Operation
î
.
37