Troy-Bilt CSV 070 Operator's Manual page 19

Problem
Excessive Vibration
Unit does not discharge
Rate of discharge slows
considerably or composition
of discharged material
changes
Unit fails to propel itself
or slips when drive
control is engaged
Cause
1. Loose parts or damaged impeller.
1. Discharge area clogged.
2. Foreign object lodged in impeller.
3. Low engine RPM.
4. Vacuum bag is full.
1. Low engine RPM.
2. Chipper blade dull.
1. Drive control cable out of adjustment.
2. Drive belt worn or damaged.
Remedy
2. See authorized service dealer.
1. Stop engine immediately and disconnect
spark plug wire. Clean flail screen and inside
of discharge opening.
2. Stop engine and disconnect spark plug wire.
Remove lodged object.
3. Always run engine at full throttle.
4. Empty bag.
1. Always run engine at full throttle.
2. Replace chipper blade or see your authorized
service dealer.
1. Follow adjustment procedure in
Maintenance & Adjustments section of
manual.
2. See authorized service dealer.
S 8 — t
ection roubleShooting
19