Troy-Bilt CSV 070 Operator's Manual page 15

Adjustments
Drive Control Cable
Adjust the drive control cable if the yard vacuum does not self
propel with the drive control engaged, or if the unit hesitates
while the engine maintains the same speed after approximately
20 hours of use.
To move the z-fitting of the drive control cable from its factory
set position in the front hole of the drive control to the rear hole,
proceed as follows:
1. Push the right side of the control out of the right hole in the
upper handle. See Figure 6-5.
1
Figure 6-5
2. Pivot control down towards the lower handle.
3. Pivot straight up to remove it from the left hole in the
upper handle. See Figure 6-5.
2
3
4. There is now sufficient slack in the drive control cable to
grasp the z-fitting with your hand and move it from the
front hole to the rear hole of the drive control. See Figure
6-6.
Figure 6-6
IMPORTANT: Make sure to insert the z-fitting into the rear
hole as it was inserted in the front hole, that is from the
outside of the drive control.
5. You may now carefully reinstall the drive control by
performing the previous steps in the opposite order and
manner of removal.
IMPORTANT: Once assembled and prior to restarting, make
sure that the cable is properly adjusted. With the drive
control disengaged, the unit should freely pull in reverse.
S 6 — M
ection
& a
aintenance djuStMentS
15