Advertisement
Your model is equipped with the Traxxas TQ 2.4GHz transmitter. The transmitter has two channels: Channel one operates the steering,
and channel two operates the throttle. The receiver inside the model has three output channels. Your model is equipped with two servos
and a receiver.
TQ 2.4GHz TRANSMITTER
Red/Green Status LED
Set Button
Steering
Trim
Throttle
Trigger
Power Switch
Battery Compartment
NITRO SLASH WIRING DIAGRAM
Steering Wheel
Antenna
Receiver
Channel 1
Steering Servo
TRAXXAS TQ 2.4GHz RADIO SYSTEM
On/Off
4-Cell
Switch
Battery Holder
CH3 - Battery
CH2 - Throttle Servo
CH1 - Steering Servo
CH1 - Channel 1*
* Not used
Channel 2
Throttle Servo
Applying The Decals
The main decals for your model
have been applied at the
factory. Additional decals are
printed on self-adhesive clear
mylar and are die-cut for easy
removal. Use a hobby knife
to lift the corner of a decal
and lift it from the backing.
To apply the decals, place one
end down, hold the other end
up, and gradually smooth the
decal down with your finger
as you go. This will prevent air
bubbles. Placing both ends of
the decal down and then trying
to smooth it out will result in
air pockets.
3
NITRO SLASH • 9
Advertisement
