Table of Contents
Advertisement
Page 18
B
EXT
-150 H Control Panel
®
1
LOCATOR
3
2
VAC 1 VAC 2
MODE
CIRCUIT LOCATOR ( 1 ): When this light is on, it indicates that cord
#2 is on a separate line from cord #1. Cord #2 supplies voltage
to the heater allowing it to heat to the proper temperature range.
HEAT MODE LIGHT ( 2 ): This light will only illuminate when the
heater is heating and will turn off when it reaches operating
temperature.
VACUUM SWITCH ( 3 & 4): Each switch turns on one vac motor.
turn both switches on for maximum lift. The vac switches illumi-
nate when turned on.
PUMP SWITCH ( 5 ): This switch will illuminate when the pump is
on.
HEAT SWITCH ( 6 ) : The heat switch will illuminate when it is
activated and will turn the heater on.
B
EXT
-300 HV Control Panel
®
5
LOCATOR
1
6
VAC
MODE
VAC ( 1 ) & PUMP ( 2 ) SWITCHES: These switches are powered
by cord #1 (4" red band). Switches are on when illuminated.
CARPET / UPHOLSTERY SWITCH ( 3 ): This switch is also
powered by cord #1 (4" red band). The carpet setting (down
position) is high pressure (approximately 300 psi). The uphol-
stery setting (up position) is low pressure (approximately 75 psi).
NOTE: Switch does not illuminate.
HEAT SWITCH ( 4): Turning on this switch (switch illuminates
when on) turns the heater on.
GREEN CIRCUIT LOCATOR LIGHT ( 5 ): When this light is illumi-
nated, it confirms that the machine is on two separate circuits.
See previous page for additional information on the circuit
locator.
HEAT LIGHT MODE ( 6 ) : The light will only illuminate when the
heater uis heating and will turn off when it reaches operating
temperature.
B
®
EXT
Clarke
4
5
PUMP
HEAT
Figure 5
Upholstery
2
3
PUMP
HEAT
CARPET
Figure 6
-150, 150H, 300HV Operator's Manual
®
6
4
Advertisement
Table of Contents
