Daily Use - Zanussi ZWG 685 User Manual

• Remove the polystyrene block and any material from
the drum.
• Pour 2 liters of water into the main wash compartment
of the detergent drawer in order to activate the

Daily use

Load the laundry
Measure out the detergent and the fabric softener
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent required, pour it into the
main wash compartment
partment if the selected programme/option it requires
(see more details in "Detergent dispenser drawer").
If required, pour fabric softener into the compartment
marked (the amount used must not exceed the
«MAX» mark in the drawer). Close the drawer gently.
Select the required programme by turning the
programme selector dial (1)
Turn the programme selector dial to the required pro-
gramme. The washing machine will automatically select
the maximum spin value provided for the programme you
have chosen. You can change this value by pressing the
corresponding button. The green pilot light of the button
5 starts to flash.
Open the door by carefully
pulling the door handle
outwards. Place the laun-
dry in the drum, one item
at a time, shaking them out
as much as possible.
Close the door.
or in the appropriate com-
ECO valve. Then run a cotton cycle at the highest tem-
perature without any laundry in the machine, to remove
any manufacturing residue from the drum and tub.
Pour 1/2 a measure of detergent into the main wash
compartment and start the machine.
The selector dial can be turned either clockwise or coun-
terclockwise. Turn to position
Switching the machine off.
At the end of the programme the selector dial must be
turned to position , to switch the machine off.
Caution! If you turn the programme selector dial to
another programme when the machine is working,
the red pilot light of button 5 will blink 3 times to indicate
a wrong selection. The machine will not perform the new
selected programme.
Spin Reduction
By pressing this button you can change the spin speed of
the selected programme or to select Rinse Hold or Night
Cycle option.
Select the available options by pressing buttons 3
and 4
Depending on the programme, different functions can be
combined. These must be selected after choosing the de-
sired programme and before starting the programme.
When these buttons are pressed, the corresponding pilot
lights illuminate. When they are pressed again, the pilot
lights go out. If an incorrect option is selected, the inte-
grated red pilot light of the button 5 flashes for 3 times.
For the compatibility among the washing pro-
grammes and the options see chapter «Washing
Programmes».
Start the programme by pressing button 5
To start the selected programme, press the button 5 , the
corresponding green pilot light stops blinking. The pilot
light corresponding to the running phase illuminates. The
appliance starts operating and the door is locked.
To interrupt a programme which is running, press the
button 5 : the corresponding green pilot light starts blink-
ing.
To restart the programme from the point at which it was
interrupted, press the button 5 again . If you have chosen
a delayed start, the machine will begin the countdown.
to reset programme/
7