How To Install The Unit On Your Bicycle; Attach The Bracket To The Stem Or Handlebar; Remove/Install The Computer - Cateye CC-MC200W User Manual

How to install the unit on your bicycle

1
2
Install the sensor and magnet
The distance from the com-
puter to the sensor is within
the transmission data length,
and the back of the computer
faces downward.
The magnet passes through the The clearance between the sen-
sensor zone of the speed sensor. sor surface and the magnet is
within 5 mm.
Magnet
Speed
SENSOR
sensor Magnet
ZONE
Bracket Bracket
band
1

Attach the bracket to the stem or handlebar

The FlexTight™ bracket can be attached to either the stem or the handlebar, depending on how the bracket fits into the bracket band.
Caution: Be sure to tighten the dial of the FlexTight™ bracket by hand.
Tightening it strongly using a tool, etc. may damage the screw thread.
When attaching the FlexTight™ bracket to the stem
When attaching the FlexTight™ bracket to the handlebar
* To mount the bracket to an aero-shaped handlebar or larger stem, use the optional nylon ties
bracket.
2
Install the sensor and magnet
Spoke
Speed
Magnet
sensor
To the SENSOR ZONE
* The wheel magnet may be installed
anywhere on the spoke if the instal-
lation conditions are satisfied.
Dial Bracket
rubber pad
Bracket
Bracket band
rubber pad
Bracket
Bracket
Bracket band
rubber pad
Bracket
Speed
sensor
SENSOR
Magnet
ZONE
Sensor Sensor
rubber pad
Stem
Dial
Cut
Handlebar
Caution:
Round off the cut
edge of the bracket
band to prevent
injury.
Speed
sensor
Sensor rubber pad
* Install the sensor above the front fork as much as possible.
CC-MC200W ENG 2
Nylon ties Magnet
(x 2)
Remove/Install
the computer
Click
While supporting it by hand,
Push it out as if lifting
the front up
Pull
securely
Cut
Nylon ties