TomTom GO User Manual page 21

USING VOICE RECOGNITION
Voice recognition is switched on by default if it is supported by your chosen
language. To switch off voice recognition and remove the button from the
Driving view, tap Voice control in the Settings menu and select Disable voice
control. The following example shows how to use voice recognition to your
Home address.
1. Tap the microphone button in the Driving view to turn on
the microphone.
2. When you hear "Say a command" followed by a tone, speak a
command of your choice. For example, you can say "Drive home."
Your TomTom is only ready to listen after you hear the tone. While you are
speaking the microphone monitor shows how well the device can hear
your vo1ce:
• A green bar means the device can hear your voice.
• A red bar means your voice is too loud for the device to recognize
individual words and understand everything you say.
• A grey bar means your voice is too quiet for the device to recognize
individual words and understand everything you say.
For some phrases, your Tom Tom repeats what you say and asks for confirmation.
Tip: For the best recognition of what you say, speak normally, i.e. without
trying to articulate the words in an unnatural way. If the command is correct,
say, "Yes." If the command is incorrect, say, "No" and repeat the command
after you hear the prompt and tone again.
Tip: To stop your TomTom from listening for further commands, say "Cancel".
To go back one step, say "Back".
20