Panasonic Microwave Ovens with Inverters Technical Manual page 12

Adjustment of the primary latch switch, the secondary latch switch,
and the short switch
1. Mount the primary latch switch, the secondary latch switch, and the short
switch to the door hook assembly as shown in the figure 7.
NOTE: No specific individual adjustments during installation of the primary
latch switch, secondary latch switch or short switch to the door hook are
required.
2. When mounting the door hook assembly to the oven assembly, adjust the
door hook assembly by moving it in the direction of the arrows in figure 7,
so that the oven door will not have any play in it.
3. Check for play in the door by pulling the door assembly.
4. Make sure that the latch keys move smoothly after adjustment is
completed. Tighten the screws holding the door hook assembly to the
oven assembly.
5. Reconnect the short switch and check the continuity of the monitor circuit
and all latch switches again by following the component test procedures.
Actuator
The gap should be
less than 0.7mm
Interlock switches
Switch
Figure 7
7