Starter Device - Jonsered 2033T Operator's Manual

Starter device

!
WARNING!
• When the recoil spring is assembled in the starter
housing, it is in tensioned position and can when
treated carelessly, pop out and cause injuries.
• Always be careful, when changing the recoil spring or
the starter cord. Always wear safety goggles for eye
protection.
Changing a broken or worn
starter cord
STOP
• Remove the filter cover and
air filter.
• Loosen the screws, that
hold the starter device
against the crankcase and
remove the starter device.
• Pull the cord out about 10
cm. Keep hold of it and
unwind two turns of the cord
from the pulley.
Release the tension on the
recoil spring by letting the
pulley rotate slowly
backwards. The cord will
not now be completely
pulled in by the spring.
• Insert and fasten a new
starter cord in the pulley.
Wind approx. 3 turns of the
starter cord on to the pulley.
Assemble the starter pulley
against the recoil spring, so
the end of the spring
engages to the pulley. Fit
the screw in the centre of
the pulley. Carry the starter
cord through the hole in the
starter housing and the
starter handle. Make a knot
on the starter cord.
MAINTENANCE
Tensioning the recoil spring
• Wind the starter cord on to
the pulley without tensioning
the spring.
• Pull the cord out about 10
cm. Keep hold of it and wind
one turn of the cord on to
the pulley.
• Pull out the whole cord and
check that all of it is pulled
back into the starter
assembly. If the handle still
hangs loose, tighten the
starter cord by winding one
more turn on to the pulley.
NOTE! Check that the
starter pulley can be turned
at least half a turn, when the
starter cord is entirely pulled
out.
Changing the broken recoil spring
• Lift the starter pulley. (See,
"Changing a broken or worn
starter cord" ).
• Remove the return spring
cassette by lifting it out of
the starter device. Ensure
that the spring does not
shoot out and cause injury.
• Lubricate the new return
spring with light oil, without
removing it from the
cassette,
• Insert the new spring
cassette.
• Insert the cord pulley and
tension the return spring.
Starter device assembly
• Assemble the starter
device, by pulling the starter
cord out first, then place the
starter against the
crankcase. Then slowly
release the starter cord so
that the pulley engages with
the pawls.
• Assemble and tighten the
screws, which hold the
starter.
• Refit the air filter and filter
cover.
31
English –