Kenwood TM-V708A Service Manual page 36

TM-V708A
Adjustment mode
• This is the adjustment mode for making adjustments or
setting levels.
• The following items can be adjusted or set.
A. Squelch open sensitivity
B. S meter (the first segment ON, all segments ON)
C. Transmission output power (lower limit frequency,
center frequency, and upper limit frequency of the
band)
D. Transmission deviation
E. DCS modulation balance
F. Tone deviation
G. DCS deviation
Adjustment mode startup method
1. Turn [PWR] OFF and insert the adjustment plug into the
data terminal of the transceiver.
2. Hold down the [F] and [TONE] keys, and turn [PWR] ON.
3. The transceiver will enter the adjustment mode and
display the following:
4. In adjustment mode, the desired band and frequency can
be selected with [VFO], [MR], [ENCODER], [MHZ], and
[BAND SEL].
5. Pressing the [ ] or [
item to the previous item or the next item among the
seven adjustment items A-G.
A. Squelch open sensitivity (value set for each band)
1. Press the [ ] and [
The current squelch level input value is displayed on the
screen and adjustment can be performed. (See the
figure below.)
2. When specified SSG input is applied to the antenna
connector and the [SET] key is pressed, an adjustment
value is set.
36
ADJUSTMENT
] key switches the adjustment
] keys to display "SQUELCH".
B. S meter (value set for each band)
1. Press the [ ] and [
The current S meter input value is displayed on the
screen and adjustment can be performed. (See the
figure below.)
2. S meter (the first segment ON)
When specified SSG input applied to the antenna
connector and the [S1] key is pressed, a value is set so
that the first segment of the S meter turns on.
3. S meter (all segments ON)
When specified SSG input applied to the antenna
connector and the [S7] key is pressed, a value is set so
that the all segment of the S meter turns on.
C. Transmission output power
(values set independently for 144MHz and 430MHz)
1. Press the [ ] and [
The current transmission output power setting is
displayed on the screen. (See the figure below.)
2. Select a desired transmission output range (HI, MID, or
LOW) with the [LOW] key.
3. Connect the power meter to the antenna connector.
Connect a microphone to the microphone connector.
4. Lower limit frequency transmission output setting.
(1)Set the lower limit frequency and press the
microphone PTT button to enter transmit mode.
(2)Adjust the power meter to the prescribed transmis-
sion power by turning the encoder.
(3)When the specified transmission power value is
reached, release the microphone PTT button and
press the [FREQ1] key to set the adjustment value.
5. Center frequency transmission output setting.
(1)Set the center limit frequency and press the
microphone PTT button to enter transmit mode.
(2)Adjustment the power meter to the prescribed
transmission power by turning the encoder.
(3)When the specified transmission power value is
reached, release the microphone PTT button and
press the [FREQ2] key to set the adjustment value.
] keys to display "S METER".
] keys to display "APC".