Fresh Food Compartment
Light and Switch
The fresh food light socket will read 120 VAC with
the door open.
Removal and Replacement
Remove 2 screws securing the control panel to
the refrigerator ceiling.
Disconnect the electrical connector shown below.
Squeeze the tab and remove the light assembly.
Tab
Disconnect the electrical connector from the fresh
food compartment light switch. Squeeze the tab
and push the light switch through the control
panel.
Clad Door Panel
The clad door panel is not on all models. Models
with the clad door require special cleaning and
handling procedures.
Removal and Replacement
Note: The screws that secure the clad panel to
the door require a Torx-30 screwdriver.
Remove the hinge cover, 2 screws, and the upper
hinge plate.
Note: Upper and lower door hinge shafts are
1/2 inch longer. The toe plate grille and top hinge
covers have been modified to adapt to these
changes.
Lift the door off of the lower hinge.
Connector
Tab
– 10 –