Control Panel - Westinghouse WDF901 User Manual

Control panel

1 On/off button (POWER)
2 Program selection button (PROGRAM)
3 Button lock button (Button LOCK)
4 Start button (START)
5 Start indicator light
6 Indicator lights
7
Button lock indicator light
8 Program indicator lights
WASHING
READY
Button LOCK
Button lock
The button lock function locks all buttons on
the control panel while the washing program
is in operation.
Follow these steps to set the Button lock
function:
1. Switch on the appliance.
2. Set a washing program.
3. Press the Start button to start the wash-
ing program.
4. Press button lock button for approxi-
mately 5 seconds, or until the button lock
indicator light flashes.
5. Button lock indicator light flashes for ap-
proximately 15 seconds.
6. When the button lock function is active
the indicator light is on with a static light.
If you press a button while button lock func-
tion is on, an audible signal indicates that
buttons are locked.
Indicator lights
The indicator light comes on when the washing program op-
erates and goes off when the washing program is completed.
The indicator light comes on when the washing program is
completed. It also has the auxiliary functions of alarm if the
appliance has a malfunction.
The indicator light comes on when the button lock function
is active.
At the end of a washing program the button
lock function is deactivated by opening and
closing the door or switching off the appli-
ance.
Important! It is not possible to deactivate
the button lock function while a washing
program is in progress. To do this you must
cancel the set program. Refer to 'Select and
start a washing program'.
Setting mode
The appliance is in setting mode when all the
program indicator lights are on.
The appliance must be in setting mode to set
a washing program.
If a program light is on, cancel the program
to go back to the setting mode. Refer to 'Se-
lect and start a washing program'.
westinghouse 5