Planet ICA-HM101 User Manual page 39

Type
Security mode
Obtain DNS from
DHCP
SSID
Channel
WEP settings
WPA settings
wireless":
Choose wired or wireless mode. However, note that wired is priority.
To select one of WLAN modes from Infrastructure or Ad-Hoc mode.
Shows which type of security the network uses. The device supports
three security methods: None, WEP, WPA_PSK, WPA2_PSK
Enable this checked box when a DHCP server is installed on the
network and provide DNS service.
This is the name of the wireless network the device is configured for.
The field accepts up to 32 alphanumeric characters. The name must be
exactly the same as that used in the wireless access point, or the
connection will not be established.
Leaving this field blank means the device will attempt to access the
nearest open network.
Chooses the wireless channel in use currently.
- Authentication:
Select Open or Shared Key System Authentication, depending on the
method used by your access point. Not all access points have this
option, in which case they probably use Open System, which is
sometimes known as SSID Authentication.
- WEP Mode:
The key types available depend on the access point being used. The
following options are available:
•ASCII - In this method the string must be exactly 5 characters for
64-bit WEP and 13 characters for 128-bit WEP.
•HEX - In this method the string must be exactly 10 hexadecimal (0-9,
A-F) characters for 64-bit WEP and 26 hexadecimal characters for
128-bit WEP.
- Web Key 1~4:
Key value of WEP.
- WPA Key:
Key value of WPA. The device uses a pre-shared key (PSK) for key
management. The pre-shared key can be entered either as Manual
hex, as 64 hexadecimal characters, or as a Passphrase, using 8 to 63
ASCII characters.
38