Option Programming - OneRemote 30012646 User Manual

Option Programming

Option programming is required only when installing the tuner. The programming is performed with a Bang &
Olufsen remote control terminal by initiating a 5 button sequence within 8 seconds after powering up the tuner.
When powering up the tuner the red control LED flashes for 8 seconds, and the programming has to be carried out
before the control LED stops flashing. When entering a button the timeout is prolonged with another 8 seconds.
If not successful the operation may be repeated. Programming starts by pressing
All options have 3 digits to be entered in between.
Option 106 is entered like this:
Control LED Indications
Red/green flash
By initial power up the LED starts flashing red/green, indicating that the tuner is in Option
Programming Mode, i.e. an option may be entered.
The Option Programming Mode is terminated after 30 secs. or prior hereto if any command except
for 0- 9, w or
Red
The tuner is powered down.
Green
The tuner is powered up or the tuner is searching for a signal to set the clock.
Intermittently turned off
The LED turns off very briefly as a command handshake indicator.
*1 If using a Beolink1000 remote control, LIGHT must be replaced with SHIFT-LINK.
www.oneremote.dk
*1 106w
is received.
and ends by pressing w
Page 6