SpeedDome
Camera Dome Outdoor
Housing
Heater Operating Instructions
RHODUL-03/04 Outdoor Housing
Cable Assembly
Housing Assembly
Bubble Assembly
RHODUL-03VR/04VR Outdoor Housing
Cable Assembly
Vandal Resistant
Housing Assembly
Vandal Resistant
Bubble Assembly
Contents
Specifications ........................................................ 4
Declarations .......................................................... 4
© 2004
Sensormatic Electronics Corporation
RHODUL-03/04 SERIES SPEEDDOME ULTRA OUTDOOR HOUSING
HEATER OPERATING INSTRUCTIONS
®
Ultra
About this Guide
These instructions explain the operation of the
heaters for the outdoor housing. The following
documents provide more information about the
outdoor housing.
•
SpeedDome Ultra Outdoor Housing Installation
and Service Guide, 8200-0184-10
•
SpeedDome Ultra Vandal Resistant Outdoor
Housing Installation and Service Guide,
8200-0184-11
Refer to your controller/matrix switcher instructions
for specific information about activating the
outputs/auxiliaries that control the heaters.
If you need assistance...
Contact your Sales Representative.
About the Outdoor Housing
The RHODUL-03/04 series outdoor housing is
used to attach the SpeedDome Ultra camera dome
to an outdoor mounting structure. It provides four
alarm inputs and one alarm output. Heater control
is available to prevent condensation from forming
on the bubble.
The heater automatically turns on when the
temperature inside the housing drops below 18°C
(64°F). The heater automatically turns off when the
temperature inside the housing reaches 23°C
(73°F) if Output/ Auxiliary 3 or 4 have not been
turned on.
The heaters can be manually turned on using the
Output/Auxiliary 3 and 4. Refer to your
controller/matrix switcher instructions for more
information about controlling outputs/auxiliaries.
CAUTION: Domes installed in a
Manchester environment do not support
latching Auxiliary 4. Only cycled
High/Low mode is available. Attempting
to use Auxiliary 4 results in turning off
Auxiliary 3.
1 of 5
8200-0184-08, REV. A