Action During A Programme - AEG LAVAMAT 47280 aqua control User Information

User information
When the appliance is switched on, the led DOOR indicates whether
the lid can be opened :
lighted in green
If :
- the START/PAUSE pushbutton flashes in red,
- and then the error code E40 appears in the display window,
- and the END light flashes 4 times and an acoustic signal is emitted 4
times,
it means there was an attempt to start a wash programme without
closing the lid properly. If this happens, push the lid firmly and start
the wash programme again.

Action during a programme

Adding of laundry
Press the Start/Pause pushbutton : the corresponding light flashes as
long as the programme is paused. You will then hear a double «click»
in the locking device when the cover opens. Press the same pushbutton
again to resume the programme.
For reasons of safety, you can not open the lid if the temperature of
the washing water is too high.
Modifying the current programme
Before modifying the current programme, you must put the washing
machine to pause by pressing on the «Start/Pause» pushbutton. If it is
impossible to make the modification, the corresponding light flashes
for few seconds. If you decide to change the programme in any case,
you will need to cancel the current programme (see below).
Cancelling the programme
If you want to cancel a programme, turn the programme selector knob
to the «off» position of the programme selector.
14
DOOR light Can the lid be opened ?
is off No
Yes