Setting Mode - Electrolux GA55LI220 User Manual

7.1 Using the detergent
A B
30
20
7.2 Setting and starting a
programme

Setting mode

The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation:
• All the programme indicators come on
• The display shows 2 horizontal status
bars.
If the control panel shows other condi-
tions, press the cancel button until the ap-
pliance is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. To set a programme, keep the appli-
ance door ajar.
3. Press the on/off button to activate the
appliance.
4. Make sure that the appliance is in set-
ting mode.
5. Press one of the programme buttons
again and again until only the indicator
of the programme that you want to set
is on.
• The programme duration flashes in
the display.
6. If you want, you can set the options.
7. Close the appliance door. The pro-
gramme starts.
1.
2.
3.
A
+ -
4.
C
5.
Starting a programme with delay
start
1. Set the programme and the options.
2. Press the delay button again and
3. Close the appliance door. The count-
• When the countdown is completed, the
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Press the release button (B) to open
the lid (C).
Put the detergent in the compartment
(A) .
If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
If you use detergent tablets, put the
tablet in the compartment (A).
Close the lid. Make sure that the re-
lease button locks into position.
• The display shows the programme
duration that decreases with steps
of 1 minute.
again until the display shows the delay
time you want to set (from 1 to 24
hours).
• The delay time flashes in the dis-
play.
down starts.
• The display shows the countdown
of the delay start that decreases
with steps of 1 hour.
programme starts.
You can set a programme, op-
tions and the delay start also with
the appliance door closed. In this
condition, you only have 3 sec-
onds after each setting before the
appliance starts to operate.
ENGLISH 61