GE Profile WPDH8800J Technical Service Manual page 55

Service Mode Test
t14 Spin Test Enter
Start
Start
Start
Power
t15 Dispenser Enter
Test
Start
Start
Start
Start
Power
t16 Bulk Pumps Enter
Test
Start
Start
Start
Power
t17 Bulk Sensors Enter
Test
Power
t18 Auto Spin Enter
Profi le
Power
t19 Bulk Manual Enter
Priming
Enter
Power
t20 Bulk Primed Enter
Status
Enter
Enter
Power
Displays "estimated" and "current" rpm. Unit begins spinning at 410 rpm
Ramps up to 1050 rpm
Ramps up to 1150 rpm
Ramps up to 1300 rpm
Ramps down and returns to service mode screen
Displays "pre-wash" and dispenser moves to position 1
Displays "main detergent" and dispenser moves to position 2
Displays "bleach" and dispenser moves to position 4
Displays "fabric softener" and dispenser moves to position 3
Repeats above sequence, starting with "pre-wash"
Drains and returns to service mode screen
Displays "left detergent pump"; water fi lls and primes left detergent
Displays "softener pump" and begins priming
Displays "right det pump" and begins priming
Continues cycling through the bulk pumps
Drains and returns to service mode screen
Displays the status of Left Detergent, Softener and Right Detergent
Returns to service mode screen
Slowly ramps up to 90, then 120, then 410
Interrupts and returns to service mode screen
Displays "prime left detergent," "prime softener," prime right detergent"
with one highlighted
Begins priming selected, with water on to rinse it from dispenser drawer
Drains; then returns to service mode screen
Displays "left detergent pump," "softener pump," "right detergent pump"
with one highlighted
Displays "left det primed status"; choose status "yes" (lines primed) or
"no" (lines not primed)
Returns back to "Bulk Primed Status"
Returns to service mode screen
– 55 –
Sequence