Dispenser Motor - GE Profile WPDH8800J Technical Service Manual

7. Remove the 2 Phillips-head screws that attach
the dispenser to the front bracket.
8. Pull the dispenser towards the rear of the
washer and disengage the dispenser from the
front bracket.
Guide Pin
Note: When installing the dispenser, ensure the
dispenser guide pin is inserted into the slot in the
side of the cabinet left side top brace and the 2 front
pins are inserted in the holes in the front bracket.

Dispenser Motor

The dispenser is operated by a 120-VAC, 60-Hz
motor. The dispenser motor receives commands
from the control board and controls dispenser
operation.
Operation of the dispenser motor can be checked
by using the Service Test Mode t12. (See
.)
Mode
Specifi c failures associated with the dispenser
motor can initiate error codes E38, E39, and E62.
(See Service Test Mode.)
To remove the dispenser motor:
Access the dispenser assembly. (See
.)
Assembly
Caution: Lock tabs on the dispenser motor wiring
harnesses are fragile. Tab breakage can occur if
excessive release pressure is applied.
Note: In the following step, it can be helpful to insert
a small fl at blade screwdriver (as shown) to remove
the wire harnesses.
1. Carefully press the lock tab and disconnect the
2 wire harnesses from the dispenser motor.
Harness Removal
2. Remove the 2 Phillips-head screws that attach
the motor and gasket inlet hose clip to the
dispenser tank. (See
3. Lift the dispenser motor vertically from the
dispenser tank.
– 30 –
Service Test
Dispenser
.)
Dispenser Assembly