Jonsered BC2125 Operator's Manual page 19

Choke: Set the choke control in the choke position.
Hold the body of the machine on the ground using your left
hand (CAUTION! Not with your foot!). Grip the starter handle,
slowly pull out the cord with your right hand until you feel
some resistance (the starter pawls grip), now quickly and
powerfully pull the cord. Never twist the starter cord around
your hand.
Repeat pulling the cord until the engine starts. When the
engine starts. return choke control to run position and apply
full throttle; the throttle will automatically disengage from the
start setting.
CAUTION! Do not pull the starter cord all the way out and do
not let go of the starter handle when the cord is fully extended.
This can damage the machine.
CAUTION!
Do not put any part of your body in marked area. Contact can
result in burns to the skin, or electrical shock if the spark plug
cap has been damaged. Always use gloves. Do not use a
machine with damaged spark plug cap.
For throttle handles with a start throttle
lock:
Set the throttle to the start position by first pressing the throttle
lock and the throttle trigger, then pressing the start throttle
button (A). Then release the throttle lock and the throttle
trigger, followed by the start throttle button. The throttle
function is now activated. To return the engine to idle, press
the throttle lock and throttle trigger again.
STARTING AND STOPPING
Stopping
The engine is switched off by moving the stop switch to the
stop position.
CAUTION! The stop switch automatically returns to the start
position. In order to prevent unintentional starting, the spark
plug cap must be removed from the spark plug when
assembling, checking and/or performing maintenance.
– 19
English