Thru-Hull Temperature Sensor T-02Msb, T-03Msb - Furuno DFF1 Operator's Manual

1.7.2

Thru-hull temperature sensor T-02MSB, T-03MSB

Select a suitable mounting location considering the following points:
• Select a mid-boat flat position. The sensor does not have to be installed perfectly
perpendicular. However, the location should not be such that the transducer may be
damaged when the boat is dry-docked.
• Locate away from equipment which gives off heat.
• Locate away from drain pipes.
• Select a location where vibration is minimal.
Sensor
Cable
Locknut
Washer
Rubber Gasket
φ21 mm
Apply sealant.
T-02MSB
Assembling temperature sensor T-02MSB, T-03MSB
Sensor Holder
Locknut
Locknut
Washer
Rubber Gasket
Apply sealant.
Holder Guide
T-03MSB
12
Thicker
than 25 mm