Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for JBL MS-BassPro SQ
Summary of Contents for JBL MS-BassPro SQ
- Page 1 Ms-BassPro sQ powered automotive subwoofer Owner’s Manual...
-
Page 2: Included Items
JBL car audio dealer about professional installation. • I f you must replace the MS-BassPro SQ’s fuse, be sure to use the same type of fuse and current rating as that of the original. In order that we may better serve you should you require warranty... - Page 3 Use a stereo RCA audio cable (not supplied) to connect the MS-BassPro before beginning installation. SQ to the head unit’s front or rear left and right line-level outputs. audIo sense sWItch: No remote turn on connection is necessary because the MS-BassPro SQ L. Front R. Front Speaker...
- Page 4 This filtering will adversely affect the MS-BassPro SQ’s performance. To get the most bass possible from your MS-BassPro SQ, splice the bare wire-to-RCA adapters into the factory system speaker outputs that are connected to the system’s largest speakers (the ones...
- Page 5 Route all power wires through grommets in the vehicle’s firewall. If factory grommets are not available, install grommets yourself. Connect the ground wire from the MS-BassPro SQ’s “GND” terminal to the nearest bare-metal surface on the vehicle. For a good connection, use sandpaper to clear the paint from the metal surface and use a screw with a star-type lock washer.
-
Page 6: Using The Subwoofer
We recommend listening at low or moderate levels while driving note: If you have connected the MS-BassPro SQ to a factory audio your car. We accept no liability for hearing loss, bodily injury or system’s speaker outputs, the audio system may fail to play or may... - Page 7 6b. If you did not install the Wireless Bass Control, adjust the 1. Make sure the head-unit power is off and the MS-BassPro SQ’s Input MS-BassPro SQ’s Input Level control to the maximum level that Level control is set to minimum.
-
Page 8: Troubleshooting
3. Subwoofer Crossover frequency selection is too high. Select a lower crossover frequency. 4. Bass level is set too high on head unit. 5. Head-unit output is distorted or blown. See your authorized JBL car audio dealer. Output gets louder when the head-unit Using speaker-level input connections: One of the speaker-level input connections is reversed (+/–). -
Page 9: Specifications
Max current draw: Idle current draw: 400mA Input sensitivity: 40mV – 20V Crossover frequency: 50Hz – 120Hz, variable Crossover slope: 12dB/octave Dimensions (W x H x D): 20-5/8" x 12-3/8" x 11-3/8" (523mm x 314mm x 289mm) Weight: 32.8 lb (14.9kg) www.jbl.com... - Page 10 8500 Balboa Boulevard, Northridge, CA 91329 USA © 2011 HARMAN International Industries, Incorporated. All rights reserved. JBL and BassPro are trademarks of HARMAN International Industries, Incorporated, registered in the United States and/or other countries. Features, specifications and appearance are subject to change without notice.