Wiring Standard Equipment - Furuno FCV-1150 Installation Manual

2.2

Wiring Standard Equipment

Power cable
This video sounder is designed to be powered with 12-24 VDC power. Use the cable DPYCY-1.5
(Japan Industry Standard) or equivalent.
6
Climp-on lug
FV2-M4
Transducer
Separate the transducer cable well away from power cables to prevent interference. Connect the
cable to the transducer port (for high frequency and/or low frequency) at the rear of the display
unit. Fabricate the cable as below.
6
Attach WAGO
connector.
(See next page.)
Note: FCV-1150 cannot accept the transducers of 53 - 65 kHz, 111 to 139 kHz and 171 - 183 kHz.
Approx. 70
Sheath
Vinyl tape
Clamp armor with cable clamp.
Power cable DPYCY-1.5 (JIS cable)
Approx. 100
Shield
Extract cores from here and cut inner materials.
Shield
Vinyl tape
30
Wrap shield around sheath 30 mm and cut
excess shield. Clamp here with cable clamp.
[Composite transducer]
BLK, RED: L side
BLU, GRN: H side
Fabrication of transducer cable
3
30
Armor
Sheath
Sheath
Vinyl tape
Note: Never connect the shield to #2 of
the WAGO connector.
6
DPYCY-1.5
Armor
Sheath
= 13.7 mm
Conductor
2
S = 1.5 mm
= 1.56 mm
(AWG16)