Sleeping Facilities; Rear Twin Beds, (190-Popular Model); Rear King-Size Bed, (190-Popular Model) - Roadtrek 170 Owner's Manual

SLEEPING FACILITIES:

REAR TWIN BEDS, (190-Popular Model):

To convert the dinette into twin beds:
1. Remove the table and leg from its receptacle and
place the table under the driver side seat cushion,
(see Picture B-P6 on page B-3).
2. Place both back rest cushions on the floor vertically
up against the seat base boxes or store if desired.
3. Pull each seat cushion 3" (8 cm) from the wall to
provide additional elbow room while sleeping.
4. Night table can be removed and stored if desired,
(see Picture B-P9).
To convert back to a dinette, perform these steps in
reverse order.

REAR KING-SIZE BED, (190-Popular Model):

To convert the dinette into a king-size bed:
1. Remove the privacy curtain from its Velcro support
on the lower edge of the suspended cupboard door.
2. Remove the table and leg from its receptacle.
3. Remove night table and store. In order to remove,
unscrew the wing bolt found on each side of the
night table, (see Picture B-P9). Store wing bolts in
the night tables drawer when not in use.
4. Place table top in center and wood insert as
shown, (see Picture B-P10).
5. Place both long bolster cushions, (back rests) in
centre rear in a tepee position, (see Picture B-P11),
then lay flat.
NOTE: The longer bolster cushion must be placed
on the driver side, so as to provide clearance for
opening the bathroom door.
6. Place the short bolster cushions forward of the
long bolster cushions and lay flat.
To convert back to a dinette, perform these steps in
reverse order.
Doc No: 21906503 Rev: 05
Picture B-P9: Wing bolts attaching the night table,
are accessed from the sides of the night table as
illustrated above, (Popular model).
Picture B-P10: Placement of support pieces for the
king size bed, (Popular model).
Picture B-P11: Placement of back rest cushions,
(190-Popular model).
Copyright © Roadtrek Motorhomes Inc. 2007
Daily living
Table top
Wood insert
B - 9