Image Advanced 2000 IMTL09905.0 User Manual page 27

PROBLEM
4. The walking belt
is off-center or
slips when
walked on
5. The displays of the
console do not
function properly
SOLUTION
a. If the walking belt is off-center, first remove
the key and UNPLUG THE POWER
CORD. If the walking belt has shifted to
the left, use the allen wrench to turn the
left rear roller bolt clockwise 1/2 of a turn; if
the walking belt has shifted to the right,
turn the bolt counterclockwise 1/2 of a turn.
Be careful not to overtighten the walking
belt. Then, plug in the power cord, insert
the key, and run the treadmill for a few min-
utes. Repeat until the walking belt is centered.
b. If the walking belt slips when walked on,
first remove the key and UNPLUG THE
POWER CORD. Using the allen wrench,
turn both rear roller bolts clockwise 1/4 of a
turn. When the walking belt is correctly
tightened, you should be able to lift each
edge of the walking belt 3 to 4 inches off
the walking platform. Be careful to keep
the walking belt centered. Then, plug in the
power cord, insert the key, and walk on the
treadmill for a few minutes. Repeat until the walking belt is properly tightened.
a. Remove the key from the console and UN-
PLUG THE POWER CORD. Next, remove
the screws from the hood and carefully re-
move the hood. Locate the Reed Switch
(17) and the Magnet (12) on the left side of
the Pulley (11). Turn the Pulley until the
Magnet is aligned with the Reed Switch.
Make sure that the gap between the
Magnet and the Reed Switch is about
1/8". If necessary, loosen the indicated
Screw (44), move the Reed Switch slightly, and then retighten the Screw. Re-at-
tach the hood and run the treadmill for a few minutes to check for a correct speed
reading.
27
a
b
a
1/8"
44
12
17
Top
View
11