Assembly & Set-Up
Contents of Crate
•
Two Ignition Keys
•
One 110V Extension Cord
Assembly
Handle
1.
Place the shift lever in the Forward-6 position
2.
Remove the lower plastic wing nut and carriage bolt from
each side of the upper handle; then raise the upper handle
assembly until it snaps over the lower handle. Make certain
the upper ends of each cable are seated properly in the
proper brackets. See Figure 3-1.
Figure 3-1
3.
Looking beneath the handle panel, check that all of the cables
(steering, auger, shift, and drive) are properly routed and
not pinched or kinked.
4.
Secure the handle by tightening the plastic knob located
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
Chute Assembly
1.
Remove cotter pin, wing nut and hex screw from chute
control head and clevis pin and bow-tie cotter pin from
chute support bracket. Position the chute over the chute
base. See Fig. 3-2.
2.
Place chute onto chute base and secure chute control head
to chute support bracket with clevis pin and bow-tie cotter
pin removed earlier. See Fig. 3-3.
•
One Snow Thrower
•
One Snow Thrower Operator's
Manual
•
One Chute Assembly
Figure 3-2
Figure 3-3
3
7