Table of Contents
Advertisement
Important Safety Instructions,
Power Lines
WARNING: To avoid electric shock, do not locate an outside antenna
system in the vicinity of overhead power lines or power circuits.
Do not locate an outside antenna system in the vicinity of overhead power lines
or power circuits. When installing an outside antenna system, take extreme care
to keep from touching power lines or circuits, as contact might be fatal.
Electromagnetic Compatibility Regulatory Requirements
This equipment meets applicable electromagnetic compatibility (EMC)
regulatory requirements. Refer to this equipment's data sheet for details about
regulatory compliance approvals. EMC performance is dependent upon the use
of correctly shielded cables of good quality for all external connections, except
the power source, when installing this equipment.
Ensure compliance with cable/connector specifications and associated
installation instructions where given elsewhere in this manual. Otherwise,
comply with the following good practices:
1.
Multi-conductor cables should be of single-braided, shielded type and
have conductive connector bodies and backshells with cable clamps that
are conductively bonded to the backshell and capable of making 360°
connection to the cable shielding. Exceptions from this general rule will
be clearly stated in the connector description for the excepted connector
in question.
2.
Ethernet cables should be of single-shielded or double-shielded type.
3.
Coaxial cables should be of the double-braided shielded type.
Continued
8
Advertisement
Table of Contents
